Page 1 of 1

Wheel offset question

Posted: Thu Jul 05, 2018 9:40 am
by Swervin_Mervin
Just looking to get a cheap wheel to run about on while we get one of the 125s alloys repaired

Original fitment is 18" 7.5j et45

Would i be ok with a 7.5j at et34?

That just means it'll sit 11mm further out right?

Re: Wheel offset question

Posted: Thu Jul 05, 2018 9:58 am
by mikeyb
Correct.

Re: Wheel offset question

Posted: Thu Jul 05, 2018 11:23 am
by integrale_evo
It's not ideal but it will be ok. You'd be better off with a pair on the axel so they're both spaced the same.

I doubt it'll cause any issues in the real world if it's only for a few days.

Re: Wheel offset question

Posted: Thu Jul 05, 2018 11:42 am
by Swervin_Mervin
Planning on getting an X1 steelie. Works out a lot cheaper than finding a spacesaver.

Plus I can use it on my 330 if needs be. Thats an 8j et34 on the front

Re: Wheel offset question

Posted: Thu Jul 05, 2018 1:16 pm
by integrale_evo
I was going to get a set of those as winter wheels when I found out you could get them for about £40 each a couple of years back. Never got round to it :lol:

Re: Wheel offset question

Posted: Thu Jul 05, 2018 1:58 pm
by Swervin_Mervin
For some reason the place thats selling it are saying I'd have to fit it to the rear and put the rear on the front.

The rears an 8J with 52mm offset so it wouldnt sit as far out but i can't see that it matters that much

Re: Wheel offset question

Posted: Thu Jul 05, 2018 2:53 pm
by integrale_evo
Ignor them, it'll be fine ( as long as it clears the brake caliper )