OV9

I'm after for cheaps a couple of 10mm thick ali/steel/notchocolate pucks made up in two different diameters with hole in t' middle for some threaded rod to pass through.

Can anyone help?

Nef got lathe(s)

Hey Tim. Yeah I have a lathe.

For what you describe you might be better buying and repurposing something off ebay.

Something like this:
https://www.ebay.co.uk/itm/223858040338 ... BMmu-npZpn

I've been finding that for quite a few things, the cheapness of generic chinese tat off ebay/wish/Aliexpress makes fabricating some stuff from scratch more effort than it's worth.

But yeah, if that doesn't work, I'll happily run you off a few bits to your spec

Thanks mate. I've ordered some 51mm aluminum round bar pre-cut into 3 lengths. What I would like then is 2 of them turned down to 50mm and 46mm (or probably a fraction under as I don't want them an exact fit) and a hole through the middle that an M12 rod can pass through.

No problem. I'll PM you my address

(have sent message, but it seems to be sitting in my outbox - shout if you haven't received)

It'll sit in your outbox 'til it's read @Nefarious

I got it, we good. Cheers Neil.